New Holland F156.6, Руководство по обслуживанию, Страница: 32 / 41

0 - 24 87726937A Edition 12/2007
REPAIR INSTRUCTIONS F106.6 / F106.6A
SAFETY INSTRUCTIONS F156.6 / F156.6A
3.6 Everyday operation
Read carefully through the sections ‘Basic safety
instructions’ and ‘Operation - General information’
and follow the instructions given.
Before starting work, examine the worksite for
embedded gas and water pipes, and electrical
power lines. Damaging these lines can cause a
life-threatening situation!
Before operating the machine, clean your work
shoes to remove clinging soil, mud, snow, ice,
grease and oil.
These could cause the shoes to slip on the steps or
pedals, thus causing unwanted movements.
If driving with the door open, engage the door in the
end position.
Warn bystanders with a horn signal before starting
work.
Do not drive with hanging loads positioned
cross-wise.
Do not attempt a U-turn with such loads. Do not
attempt to position such loads using the articulated
joint.
Stop working if anyone is standing within the danger
area around the machine. Start working only when
all persons have moved out of the danger area.
Always operate and use the machine in such a way
that it remains stable.
Ditches and trenches can collapse. Keep at a safe
distance.
3.7 Using the grader
Due to the versatility of the grader and the diversity
of the materials, there are many possible
applications and working methods. We therefore
recommend having the driver instructed by the
manufacturer.
Read and pay attention to: ‘Operating instructions -
Warming up’.
Do not exceed the machine’s permitted
transverse/longitudinal tilt angle. Doing so will
reduce or interrupt the engine lubrication.
The permitted tilt angles of the machine are:
•
Transverse tilt:
Left / right 35° 35°
•
Longitudinal tilt:
Downward / upward 35° 35°
If the engine temperature, oil pressure or alternator
warning lamps come on, lower the working
equipment immediately and switch the engine off.