New Holland E175C, Руководство по обслуживанию

Страница: 30 / 51

INTRODUCTION
Basic instructions - Preparation for performance tests
Observe the following rules in order to carry out performance tests accurately and safely.
The machine
1. Repair any defects and damage found, such as oil
or water leaks, loose bolts, cracks and so on, before
starting to test.
Test area
1. Select a hard and flat surface.
2. Secure enough space to allow the machine to run
straight more than 20 m ( 787.4 in ), and to make a full
swing with the front attachment extended.
3. If required, rope off the test area and provide sign-
boards to keep unauthorized personnel away.
Precautions
1. Before starting to test, agree upon the signals to be
employed for communication among coworkers. Once
the test is started, be sure to communicate with each
other using these signals, and to follow them without
fail.
2. Operate the machine carefully and always give first
priority to safety.
3. While testing, always take care to avoid accidents due
to landslides or contact with high-voltage power lines.
Always confirm that there is sufficient space for full
swings.
4. Avoid polluting the machine and the ground with leak-
ing oil. Use oil pans to catch escaping oil. Pay special
attention to this when removing hydraulic pipings.
Make precise measurement
1. Accurately calibrate test instruments in advance to ob-
tain correct data.
2. Carry out tests under the exact test conditions pre-
scribed for each test item.
3. Repeat the same test and confirm that the test data
obtained can be produced repeatedly. Use mean val-
ues of measurements if necessary.
TULI12ECX0095AA
1
TULI12ECX0096AA
2
47494131A 11/03/2013
25