New Holland Boomer 41, Руководство оператора

Страница: 161 / 216

7 - MAINTENANCE
If you must inflate or service tires, follow these safety
precautions to avoid injury or fatality:
• Make sure the rim is clean and free of rust.
• Lubricate both tire beads and rim flanges with soap
solution. Do not use oil or grease.
• Use a clip-on tire chuck with a remote hose and
gauge. This allows the operator to stand clear of the
tire while inflating.
• NEVER INFLATE TO OVER
241 kPa ( 35 psi ) TO
SEAT BEADS. If beads have not been seated by the
time pressure reaches
241 kPa ( 35 psi ), deflate the
assembly, reposition the tire on the rim, relubricate
both tire bead and rim flanges, and reinflate. Inflation
beyond
241 kPa ( 35 psi ) with unseated beads may
break the bead or rim with explosive force sufficient
enough to cause serious injury.
• After seating the beads, adjust inflation pressure to
recommended operating pressure.
• Do not inflate a tire unless the rim is mounted on the
tractor or is secured so that it will not move if the tire
or rim should suddenly fail.
• Do not weld, braze, otherwise repair, or use a dam-
aged rim.
• Never attempt tire repairs on a public road or high-
way
• Use jack stands or other suitable blocking to support
the tractor while repairing tires.
• Ensure jack has adequate capacity to lift your tractor.
• Place jack on a firm, level surface.
• Do not place any part of your body beneath the trac-
tor or start the engine while the tractor is on the jack.
• Before adding ballast to the tires, refer to
6-2 , 6-2 ,
6-4 , and 9-3 .
Front axle differential oil level
NOTE: Check the front axle differential case and final re-
duction gear case oil level after every 50 hours of operation.
1. With the tractor standing level and the engine off, check
the front axle oil level using the dipstick (1) . located on
the left side of axle.
93100889
1
7-23