Vinyl Beam Assembly
Insert two short aluminium stiffener into one long aluminium
stiffener to create full length piece.
Repeat so you have four full length beams.
Insert one end of the beam into the joiner.
Pushfirmly until the extrusion bottoms out inside the joiner.
Insert one assembled aluminium stiffener (with aluminium block
facing up),
into the pocket of the vinyl beam past the joiner.
Push until aluminium block is centered about the joiner.
Slide a second beam over the aluminium stiffener and into the joiner.
Screw the joiner to vinyl beams and aluminium insert using 1-1/2”
screws. The bottom and top holes will need to be pre-drilled
(use drill bit provided).
Apply a bead of vinyl glue to the inside of the decorative end
cap as shown and firmly attach to the end of the beam assembly.
Note: Aluminium block should always face up and will affect the
orientation of the end cap.
1
2
3
STEP FOUR
4
5
6
Aluminium block should face up
1
2
3
5
4
6
10
Biltmore Pergola