Master SEL mode on the REV RETURN Section
To Set How the Rev Returns Feed The Cues
The Rev Return can be sent to either Cue or both of them.
u
Press and hold down
LOCK
on the Main Monitor Panel, then press
RTE
SEL
to enter Master SEL mode.
All of the console
SEL
leds will flash. Most of the 8T strip controls will have
their functionality blocked out, apart from those indicated in white, left.
The
1/2
LED is tri-state in colour and uses these colours to indicate which
Cue(s) the Rev Return is routed to.
•
Cue
1
– Red
•
Cue
2
– Green
•
Both
cues – Yellow
For each press of the
TO CUE
level control, you will cycle round the
following feeds (the
PRE
LED will light when you are sending these Cues
Pre, Pan/Bal or Width control otherwise they are fed
Post
-controls):
•
Cue
1
,
Post
fader (Red)
•
Cue
1
,
Pre
fader (Red)
•
Cue
2
,
Pre
fader (Green)
•
Cue
2
,
Post
fader (Green)
•
Both
Cues
,
Post
fader (Yellow)
•
Both
Cues
,
Pre
fader (Yellow)
The Rev level control will be still be available in Master SEL mode, so it
will be possible to audition the audio on the Cues (via AFL) as you set
them to the above states.
u
At any point in the cycle, press
RTE SEL
to exit Master SEL Mode to
apply these changes.
- 55 -
