REVERB RETURNS / AUX MASTERS Section
REV Return Section
The free-running large encoder knob at the top of the strip sets the input
level of the Rev Returns. It has a range of -∞ to 0dB. The DAW LED (and
associated encoder push switch) is not used in the present software.
TO CUE
Sets the amount of Reverb Return signal sent to the Cue mixes (it can be
sent to either cue or both of them).
u
Press to select on/off.
See the section below on
Master SEL Mode
on how the Rev Returns feed
the Cue.
WIDTH
Sets the width of the stereo image from narrow (hard left) to Wide (hard
Right).
u
Press to enable.
If
MONO
is pressed (below), the
WIDTH
LED will flash when pressed to
indicate it is not an available control in mono.
PAN/BAL
Works in conjunction with the
MONO
button to the left.
u
Press to enable.
•
When the
MONO
button is pressed, this control acts as
Pan
.
•
When the
MONO
button is
not
pressed, this control acts as a
+/- 6dB
Balance Control.
MONO
Turns the stereo signal into mono, where each of the Reverb L and R are
sent to the Mix Outputs L and R equally.
ON
Switches the Reverb Return On/Off.
It can also be switched off by
CH
,
MON
or
8T
solo systems in Destruct
Mode, if selected.
ISO
Isolates the Rev Return from the Solo System so that when any other Solo
is detected on the console, the Reverb Return is not Cut.
u
Press to enable.
AFL
Switches the AFL for the Reverb Return into the Main monitoring.
- 54 -
