Software Operation
u
When the Genesys console is running, click
Settings
/
FireWire
Setup
to open the FireWire setup page.
Board Mapping
This mapping only needs to be done once, or when cards are added or
removed, or when the console is reconfigured.
u
Click the
Board Mapping
button to open the mapping screen.
The screen only shows those cards that have been detected on boot-up,
so for example, on a 56-fader system that only has 3 Master and 3 Slave
cards, only the first three rows on screen will be available for mapping, as
shown left.
Each Master card needs to have its dip-switches set to unique settings.
Please turn to page 134 to see how to set the dip-switch addressing.
In the console, this Master card's associated Slave card must be in the
immediate next 8-fader section without any other 8-fader sections in
between.
u
For each of the Master cards, inform the software in which position it is
located by matching the ID dip switches on the card with the physical
position on the desk from the pull-down menu.
u
Ensure the associated Slave card is in the physical position displayed in
the right-hand column.
u
Once the mapping has been completed correctly, click
OK
to close.
NB:
The
OK
button will be greyed-out and unavailable until a valid
combination of boards has been set.
- 151 -
