Container Cleaning System TANKO®EX-R64T
7 Maintenance
Translation - Operating/installation instructions 2020/03
61/80
CAUTION
Danger due to freely rotating components on the device!
When grasping the device at the media connection or at one of the spray heads of the
attached devices, the device can suddenly and quickly turn due to the built-in ball
bearings until it reaches its center of gravity.
There is a risk of minor contusions.
When handling, e.g. unpacking, transportation without packaging,
assembly/disassembly and maintenance work, pay attention to the free rotation
possibility and grasp appropriately firmly, preferably at the distribution.
If necessary, provide free space for the rotary movement
Wear protective gloves when working on the device.
CAUTION
Fault as a result of soiling, foreign matter or damage to the device!
Foreign matter such as scale, burrs, chips, etc. can restrict the flow or enter the pipe
system and cause malfunctions or damage to components, including gaskets. That can
result in hazards that endanger the functional safety of the device.
There is a risk of minor or moderate injuries.
Take suitable measures to prevent the ingress of dirt and foreign matter via the
interfaces of the device.
Before starting work, make sure that all necessary tools, auxiliary materials and
information are available and observe the instructions for the interfaces.
When lifting the device out of the container, maintain a distance from the inner wall of the
container and surrounding components (e.g. agitators), to avoid scraping or knocking.
Place the device on a firm surface after removing it.
7.3.1
Removing the Device
1.
WARNING
Risk of the device falling down accidentally!
The device may hit personnel when falling.
There is a risk of severe physical injury.
Hold the device firmly when installing/removing it.
There must be nobody beneath the device when installing/removing it.
2. Remove thread lock (locking pin, welding points)
3. Release the threaded connection between media connection and media supply with belt
wrench/strap wrench.
4. Unscrew the device from the pipe for the media supply.
