Container Cleaning System TANKO®EX-R64T
56/80
Translation - Operating/installation instructions 2020/03
7 Maintenance
7
Maintenance
The following safety instructions apply to all work on the device listed and described in this chapter, and
must be observed at all times.
Only use original spare parts when replacing parts of the device. A function check must be performed after
every repair (see
Section 6.2 Function Check
WARNING
Risk of accident caused by incorrectly performed maintenance and repair work!
Improper maintenance, falling components or failure to adhere to the listed safety
instructions can cause accidents.
There is a risk of death or severe physical injury.
Only have experts perform work on the device.
Do not work on the device unless it is disconnected from the power supply,
depressurized and in cold condition.
Maintain a safe distance when working on the device.
We recommend that you provide 1 m space for free movement around the device and
container.
7.1
Safety Instructions for Maintenance
NOTE ON EXPLOSION PROTECTION
Work on the device in a potentially explosive atmosphere is PROHIBITED!
If this is not observed, the explosion protection could be disabled.
Only allow instructed personnel to work in potentially explosive atmospheres.
The personal protective equipment must meet the explosion protection requirements.
Do not use a tool that could create sparks.
DANGER
Risk of fatal injury from electric shock through contact with live parts!
Activated electrical components are live with dangerous electrical voltage and may
perform uncontrolled movements.
There is a risk of death or severe physical injury.
Allow only qualified electricians to perform work on the electrical system.
Before starting work, observe the work steps of the switch-off procedure (see
Section 7.2
Cover adjacent live parts to prevent contact.
Pay attention to hazards caused by electrical current (e.g. warnings).
