Container Cleaning System TANKO®EX-R64T
5 Installation
Translation - Operating/installation instructions 2020/03
45/80
Figure 5.2-1: Interfaces
The device has the following interfaces:
Interfaces
1 Media connection [MA] (is also the process connection [PA] for installation)
3/4" internal thread
2 Device connection for TANKO-EX-S30 or TANKO-EX-RB-30 cleaning devices
G3/8" external thread
3 Do NOT place the strap wrench/belt wrench in the bearing area
5.2.2
Installation Position
The preferred installation position of the system is a vertical media connection (pointing up or down),
the axis with the cleaning heads aligned horizontally, with a maximum permissible deviation of 5°.
When installed, the cleaning devices move horizontally in a circle around the downpipe (media
connection) and at the same time around their own axis.
5.2.3
Installing the Device
1.
WARNING
Risk of the device falling down accidentally!
The device may hit personnel when falling.
There is a risk of severe physical injury.
Hold the device firmly when installing/removing it.
There must be nobody beneath the device when installing/removing it.
2
) NOTE
Dirt and foreign matter in the device!
Functional safety and reliability may be impaired.
During installation, make sure and check that there is no dirt or foreign matter in the device (e.g.
small particles, sealing material).
3) Screw the TANKO-EX-S30 or TANKO-EX-RB30 devices with the internal thread onto the pipe end of
the device carrier.
NOTE
There is a risk of damage to the thread if the tightening torque applied to the threaded device
connection and the pipe is too high!
The tightening torque for the threaded connection between the device and the pipe depends on
the material of the TANKO-R64T and of the cleaning device.
NOTE
When tightening and loosening the device, the bearing of the cleaning device could be damaged
(see TANKO-S/-RB ATEX operating instructions)! The rotation performance could be impaired!
Do NOT place the strap wrench/belt wrench in the bearing area.
4. Tighten the threaded device connection to the pipe with the strap wrench/belt wrench.
The tightening torque for the threaded connections between the media connection and the pipe
depends on the material of the pipe and of the cleaning device.
5. Push the TANKO-R64T with the internal thread onto the pipe for the media supply.
NOTE
There is a risk of damage to the thread if the tightening torque applied to the threaded
connection between the media connection and the pipe is too high!
