Neumann.Berlin KH 120 D, Руководство по эксплуатации

Страница: 10 / 24

8
| KH 120
X
Position the loudspeaker so that there is a direct line of sight from the listening position to
the bass and tweeter drivers .
Connecting the audio cables
Connecting analog cables
X
Connect the left and right output of your audio source to the XLR sockets of the respective
loudspeaker .
XLR XLR
Left signal Right signal
Analog Source
X
Use an XLR adapter (not supplied) to connect unbalanced cables (e .g . RCA cables) .
X
Use the following wiring if you want to make your own XLR adapter:
Wiring Pin Signal
Source (RCA) Loudspeaker (XLR-M)
1 Audio ground
2
3 Signal -
Connecting/disconnecting the KH 120 to/from
the mains power supply
To connect the KH 120 to the mains power supply:
X
Make sure that the on/off switch
3
is set to “OFF” .
X
Connect the IEC connector of the supplied mains cable to the mains socket
4
.
Power Source
3 4
X
Connect the mains plug of the mains cable to a suitable wall socket .
To disconnect the KH 120 from the mains power supply:
X
Set the on/off switch
3
to “OFF” .
X
Pull the mains plug out of the wall socket .
Connecting
XLR cables
EN