14
ATTENTION!
If the burner temperature is too high, the flame will be automatically lowered and the
height regulation blocked. If the temperature keeps increasing, the flame will be extinguished
automatically (COOLING THE DEVICE, TEMPERATURE TOO HIGH).
c)
Flame extinguishing
To extinguish the flame:
- Press or
- Press STOP. In this case, an additional system of fans will be enabled to cool the burner faster.
The message (COOLING THE DEVICE) indicates that the burner is being cooled. You can ignite the flame
again when the burner is cooled and the message (READY) is displayed.
d)
Turning the burner off
To turn the burner OFF, press .
The burner will be turned OFF automatically if an error occurs (see the error table on the next page).
e)
Sleep function
The SLEEP function extinguishes the flame after a set period of time (max. 3 hours).
To turn on the sleep function:
When the flame is ignited and the message (WORKING) is displayed, press and hold + and – for 10
seconds. Then, press + to set the time after which the flame will be extinguished and accept with –. A
timer will appear in the right upper corner of the display, indicating the time remaining until the flame
is extinguished.
5.5 Wireless Control Configuration
a)
Download Planika N-control app on your mobile device from
any app store.
b)
To start the configuration, select Wi-Fi CONFIG in the menu.
Time to finish the configuration is 5 minutes.
c)
Enable the Wi-Fi connection on your mobile device and connect
to planika123 network (if the network is not visible on the list,
disconnect the power supply from the burner for 10 seconds
and start the configuration again). This operation can be done
with only one burner at a time. Using more than one burner
during configuration can lead to errors.
d)
Start the application on your mobile device. The burner will
appear in the manager window.
e)
Connect to the burner and go to SETTINGS. Choose the connection mode (MODE) and security protocol
(SECURITY). Enter the network name (SSID_NAME) and password (PASSWORD).
f)
If static IP is required, enter IP ADDRESS, NETMASK and GATEWAY. For dynamic IP enable DHCP. Accept
the settings by pressing SUBMIT.
g)
Connect to the selected/created network in the Wi-Fi menu on your mobile device.
h)
The application will automatically search for the burner.
Scan or click to watch the video
instruction
https://www.youtube.com/watch?v=6hnhCXk3UDc
MODE
OFF
Blocks wireless
control via Wi-Fi.
STA
Connection with your local
network and a router.
AP
Direct connection between
the burner and your mobile
device (outside your local network).
SECURITY
--
Choose the security protocol used
in your local network
(usually WPA/WPA2).
Choose security protocol WPA
(recommended) or WEP.
SSID_NAME
--
Enter the name of your local network.
Create a network name.
PASSWORD
--
Enter your local network password.
Create a network password
(min. 8 characters).