NetworX Architech, Инструкция по монтажу и установке

Страница: 1 / 24

1
ArchiTech Cylindrical Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
ArchiTech
™
by Networx
™
FOR CYLINDRICAL LOCKS USING SURFACE-MOUNTED NETWORX CONTROL UNITS
MOUNTING AND INSTALLATION INSTRUCTIONS
© NAPCO Security Technologies, Inc. 2016 WI2104B 09/16
DESCRIPTION
These instructions detail the hardware installation procedure for the ArchiTech
cylindrical door locks
using the
Surface
-Mounted Networx Control Units
for hollow metal and solid wood doors.
Installation instructions for the
Door Contact Sensor
,
Door Contact Magnet
(installed in the door jamb) and the
Oval
and
Rectangular Proximity Readers
are also included.
PARTS OVERVIEW
For reference, the images in Fig. A display each component (not to scale). In addition to the various screws and tem-
plates included with your lock, please note that one of two types of
Proximity Readers
are included, either
Oval
or
Rectangular
. In addition, one of two types of
Door Contact Magnets
(installed in door jamb) are included, ei-
ther 3/8" or 3/4" diameter.
Wires for the
Door Contact Sensor
,
Proximity Reader
and
Cylindrical Lock
motor are routed through the door
and are plugged into the rear of the
Surface-Mounted Networx Control Unit
, mounted on the inside (" protected" )
door surface.
The
Cylindrical Lock Motor Wire
can be routed within hollow metal doors; with solid wood doors, this
Cylindrical Lock
Motor Wire
can be routed on the door surface but behind a
Wiring Plate
(HW1945), or an optional
Cylindrical
Drill Jig
(part #N90S1DJ) is available to allow a hole to be drilled allowing this wire to be routed through the
solid wood door.
REQUIRED TOOLS
In addition to the standard door prep kit tools used to install a cylindrical lock into a metal or wood door (standard ASA
161 door prep cross-bore hole saws, Phillips and flat head screwdrivers, etc.), you will need: A small
level
, and the
following drill bit sizes:
5/8"
,
3/8"
,
3/4"
and
7/64"
. If the
Cylindrical Drill Jig
(part #N90S1DJ) is used, a
round or cir-
cular file
is needed to remove burrs in holes and to file a pathway groove in wooden doors for the
Cylindrical
Lock Motor Wire
.
IMPORTANT:
For installation on UL Listed Wood Fire Doors, fill the through hole wire passage with UL Clas-
sified Fire Stop Sealant after connecting all wiring and testing the Lock.
FIG. A: OVERVIEW OF BASIC PARTS (NOT TO SCALE)
"SURFACE-MOUNTED" NETWORX
CONTROL UNIT
AND ITS MOUNTING PLATE
OVAL AND RECTANGULAR
PROXIMITY READER COVERS AND
MOUNTING COMPONENTS
USE WIRING PLATE (LEFT)
OR OPTIONAL CYLINDRICAL
DRILL JIG (RIGHT)
OR
DOOR CONTACT
MAGNET
(TWO TYPES)
OR
DOOR
CONTACT
SENSOR