6
5-4. Wake up Z311G
When users would like to setup or acquire data from the device which is in sleeping mode, we have to wake
up the device as the following steps:
Step1. Press and hold both
Binding Key
and
Auxiliary Key
.
Step2. Until the indicator flashes
red
twice,
release both buttons.
Step3. The indicator will flash
5 times
while broadcasting.
5-5. Battery
When the operating voltage is lower than 2.1V, the indicator will flash
red
once
per hour. Z311G will send a
low-power report to the ZigBee network.
5-6. Change the Light Source Mode
Users could change the Light Source Mode via ZiG-BUTLER to enhance the light sensing accuracy. It
includes:
1. Natural Light
2. Energy Saving Lamp
3. Filament Lamp
4. User-defined
5-7. Calibration
Users could change the calibration setting via ZiG-BUTLER while the default Light Source Mode does not
suit your needs.
5-8. Light Level Report
Z311G detects the light level every 5 minutes by default after binding. To assign the reporting conditions,
users can modify the settings via netvox ZigBee application ZiG-BUTLER (please refer to Chapter 7).
5-9. Restore to Factory Setting
To restore it to factory setting, please follow the steps:
Step1. Press and hold both
Binding Key
and
Auxiliary Key
for 5 seconds.
