Example#2
based on MinTime = 15 Minutes, MaxTime= 1 Hour,
PowerChange=2W
MaxTime
MinTime
MinTime MinTime
MinTime
0H
15
th
M 30
th
M 45
th
M
1H
2H
Example#3
based on MinTime = 15 Minutes, MaxTime= 1 Hour,
PowerChange=2W
MaxTime
MinTime
MinTime MinTime
MinTime MinTime MinTime
0H
15
th
M
30
th
M
45
th
M 1H 1H15
th
M
1H30
th
M
Remarks:
1.
Compare the collected data with the last reported data. If the amount of data change is greater than ReportableChange, the device
will report based on the MinTime interval. If the data change is not greater than the last reported data, the device will report based on
the MaxTime interval.
2.
For the energy consumption detection device, because the device is a constant power supply device, it is not recommended to set the
MinTime interval value too high in order to obtain the status information in real time. It is recommended to use the default 2 seconds.
If users need to control frequent report recommendations to adjust ReportableChange and MaxTime.
3.
After the device sends a packet (regardless of whether the data has changed, such as pressing a button or the maximum time is due),
another MinTime / MaxTime calculation cycle is initiated.
6. Load Property
*When the current exceeds the rated load current range, the device will automatically disconnect the load within 2 seconds after the
detection.
Rated Load
（
AC
）
Max. Load
Max. Inductive Load
（
cosφ=0.4
）
Max. Load with
Electric Motors
Overload Protection
with Auto Power
Cutoff
EU Type
：
16A/250V
UK Type
：
13A/250V
AU Type
：
10A/250V
US Type
：
15A/125V
< 400W
8A/250V
1.5HP/250V
YES
Collects data
13W
REPORT ON
Collects data
9W
Does not report
Collects data
10W
REPORTS
Collects data
REPORTS 10W
Collects data
REPORTS 11W
Collects data
9W
Does not
report
Collects data
12W
Does not report
Collects data
14W
Does not report
Collects data
13W
Does not repor
t
Collects data
14W
REPORT
Power Change
over 2W
Collects data
10W
Does not
report
Collects data
9W
Does not
report
