5
Low Voltage Warning
Low Voltage
6.8V
5. Data Report
The device will immediately send a version package report and after 180s send two uplink packets with temperature and
humidity, CO2 and battery voltage at 30s interval.
The device sends data in the default configuration before any configuration is done.
Default setting:
ReportMaxTime: 720min
ReportMinTime: 30s (Interval time of two packets)
*The ReportMaxTime must greater than or equal to
ReportType count *ReportM 10
(units: seconds)
* ReportType count = 2
*
It would take about
180
seconds for the CO2 sensor to sample and process the collected CO
2
value after being powered
*
It would take about
180
seconds for the CO2 sensor to sample and process the collected CO
2
value if you were to
manually trigger the device by pressing the button, please be patient.
Note:
1.
The device report interval will be programmed base on the default firmware which may vary.
2. The interval between two reports must be the maximum time
3. R72615A does not support the ReportChange so the configuration is invalid.
4. Report cycle will be based on ReportMaxTime period when sending data packet (beginning to the end of the first data
as a period)
5. The device also supports Cayenne's TxPeriod cycle configuration instructions. Therefore, the device can also perform a
report according to the cycle time of the TxPeriod value; and whether the report period is ReportMaxTime or TxPeriod
will be depending on which cycle time is configured last time
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
