12
6.2 Device Installation
There are three installation methods: fully buried installation, semi-buried installation and direct installation.
The installation methods are as follows.
6.2.1 Device Interference Source
There should be no metal materials such as aluminum alloy, iron, copper plate, etc. around the device.
There should be no water around the device.
Please keep the environment around the device clean and avoid the coverings on the device; otherwise, it will affect the normal
operation of the device.
6.2.2 Precautions For Battery Use
If the battery needs to be replaced within 10 minutes after the device is turned on, users need to the magnet approach to the top
cover for 10 seconds to restore the factory settings after replacing the battery. (The hardware has its own anti-battery
passivation power supply to actively eliminate the battery hysteresis.) Then, turn on the device, and it can work normally.
Note:
Please do not disassemble the device unless it is required to replace the batteries.
Do not touch the waterproof gasket when replacing the batteries.
Please use suitable screwdriver to tighten the screws (if using an electric screwdriver, it is recommended to set the torque as
4kgf) to ensure the device is impermeable.
Direct Installation
Semi-Buried Installation
Fully Buried Installation
Ground
