15
7. Installation
When the device turns on, please make sure that the device is on the horizontal surface. Then, use the device after it join the
network successfully. The purpose is to ensure that the angle calibration is complete.
7.1 The waste bin with frame
7.2 The waste bin without the frame but an upper cover
The waste bin without the frame but an upper cover needs to be drilled out the required mounting holes in the cover, and then
install the sensor on the cover. User should find and make sure the installation location that is parallel to the bottom of the waste
bin. Namely, the detecting direction is perpendicular to the bottom of the waste bin.
When the device is installed under the cover of the waste bin, the appearance may be like the figure below.
When the cover is completely opened, the inclination angle is about 90°
(Errors in the result of the device test. The actual inclination angle is about 86°.), and the horizontal plane is 0° reference plane.
R718X
The bottom of waste bin
Outer frame
Install the sensor above the outer frame,
and make it be parallel to the bottom of
the waste bin.
Horizontal Plane
