9
Neutral Wire
Live Wire
Detected Object
L
←
K
Power Supply
Note:
1)
The device only wakes up and performs data sampling according to MinTime Interval. When it is sleeping, it does not
collect data.
2)
The data collected is compared with the last data reported. If the data variation is greater than the ReportableChange value,
the device reports according to MinTime interval. If the data variation is not greater than the last data reported, the device
reports according to MaxTime interval.
3)
We do not recommend to set the MinTime Interval value too low. If the MinTime Interval is too low, the device wakes up
frequently and the battery will be drained soon.
4)
Whenever the device sends a report, no matter resulting from data variation, button pushed or MaxTime interval, another
cycle of MinTime/MaxTime calculation is started.
6. Installation
1. When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall with screws.
2. When installing the R718NL3 series current transformer, please separate the live and neutral wires of the wire to be detected,
and only take the live wire through current transformer and start the measurement according to the wiring below:
CT Wiring Schematic Diagram (Current direction K→L)
