NT-1202G
V18.5.21
Quick Setup Guide
Get Started
:
Connect your PC and stand via the USB Cable .After plug it on your USB port, you can start to use it.
(US keyboard by default) If you use other type of keyboard , please refer to below "keyboard language type" to set the
keyboard language before use it.
If you want to do other configurations please refer to below programming barcodes.
Firmware Version:
Read below command barcode to check scanner firmware version.
2.4GWISX_20180514
Below programming barcodes are applied for version - 2.4GWISX_20180514
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and communications settings. If you
need to change these settings, programming is accomplished by scanning the bar codes in this guide. An asterisk (*) next
to an option indicates the default setting.
Interface (Optional)
USB Interface USB -KBW
When you connect the scanner to the Host via a USB connection, you can enable the USB HID-KBW feature by scanning
the barcode below. It works on a Plug and Play basis and no driver is required.
USB Serial Port
If you connect scanner to the Host via a USB connection, the USB COM Port Emulation feature allows the Host to receive
data in the way as a serial port does.
