Installation instructions Universal Device Rack Netti III Comfort HD / XHD / Mini SW 35
MD 0167UK Installation instructions - Universal device rack
08-2018
My.Netti.com Page 7 of 10
6. I
nstalling the protective cover / second level
The protective cover is available as an option at additional cost.
The protective cover can be used as an upper platform (Fig. 13) can also be
used to support additional light-weight devices with a total weight of up to 4
kg.
2 cut-outs are available, one for inspection, the other for the oxygen cylinder.
Each cut-out has a plate that is secured by a side screw. You can remove the
plate if you remove the side screw (Fig. 14).
Unscrew the 2 nuts on the inside of the platform. There is one at the back, (Fig. 16) and one at the front
(Fig. 17). Pull the screws out. Place the protective cover on the platform so that the side panels are inside
the raised edges of the platform (Fig. 18 & 19) and the sloping edge of the protective cover faces the
wheelchair (Fig. 25). Screw the side panels together with the platform and the support tubes.
Warning do not exceed the maximum load on the protective
cover of 4kg
7. Installing an oxygen cylinder (requires the optional second level)
When fitted with the optional protective cover the universal device rack can
hold a standard 2 l oxygen cylinder.
Remove the plate from the round 119 mm cut-out in the protective cover
Fig14 & Fig. 20
Line the cut-out with the beading provided, see Figure 20.
This reduces the inner diameter to 115 mm.
Place the side panels of
the protective cover
inside the raised edges
of the platform
Fig. 16
Fig. 17
Fig. 19
Fig. 18
Fig. 13
F
F
Fig. 14
Fig. 20