NetScreen Technologies NetScreen-10 Series, Руководство по установке

Страница: 30 / 48

&KDSWHU&RQILJXULQJWKH1HW6FUHHQIRUWKH)LUVW7LPH
1HW6FUHHQ
&RQQHFWLQJYLD7HOQHW
Telnet operates over TCP/IP networks. It allows you to configure the device using
the command line interface (CLI).
Before you begin, be sure you connected the NetScreen device hardware to the
network as outlined in Chapter 2.
1. Establish a Telnet connection to the NetScreen device.
2. For Host name, type: 192.168.1.1, the NetScreen-10/100 default IP address.
/RJJLQJ2Q
To log on, enter the default administrator login name and password.
1. At the login prompt, enter
netscreen.
2. At the password prompt, enter
netscreen.
6HWWLQJWKH6\VWHP,3$GGUHVV
To administer the NetScreen device over a network connection, you must change
the system IP address. The NetScreen-10/100 ships from the factory with a
default IP address of 192.168.1.1. To change this to an address on the same subnet
as the other network devices to which the NetScreen-10/100 is connected, enter
the following command, substituting your system IP address for the letters:
At the command line enter:
a.set admin sys-ip <a.b.c.d>
b.save
$OORZLQJ2XWERXQG7UDIILF
If you want to configure the NetScreen device for Transparent mode, you do not
have to define IP addresses for the Trusted, Untrusted and DMZ interfaces.
Initial configuration is complete.
To configure the NetScreen-10/100 device for Network Address Translation (NAT)
mode or Route mode, you must configure the Trusted, Untrusted and DMZ
interfaces.
a.set policy outgoing “inside any” “outside any” any permit
b.save
Note: Select vt100 for Terminal type.