Netscout OneTouch AT 10G, Руководство пользователя

Страница: 56 / 248

OneTouch AT 10G
User Manual
54
3
Set appropriate parameters for your network. See your
network administrator for details. See also: “Wired” on
page 172 .
Establish a Fiber Connection
Install or Remove the SFP+ Fiber Adapter
To install an SFP+ Fiber adapter, remove the protective cap from
the adapter and slide the adapter into the fiber port. To remove,
gently pull the adapter’s bail. If the adapter has retention tabs,
press and hold the tabs on the sides of the adapter and pull it
from the fiber port.
The analyzer supports 1000M and 10G SFP+ fiber adapters.
Run AutoTest
AutoTest provides a comprehensive test of network
infrastructure, along with user-defined tests.
The OneTouch analyzer does not initiate any link, user test, or
infrastructure test activity until you run AutoTest.
Tap the AutoTest button (located at the lower-right corner
of the HOME screen) or press the AutoTest key

(located on
the front panel). The analyzer will:
 Link on active ports
 Obtain IP addresses
 Run Network Infrastructure Tests (listed on page 66)
 Run User Tests (including the Connect (TCP) user test that
you just created)
 When multiple user tests are present, they are run
consecutively, starting with the lower-left test on the
bottom test tier and finishing with the upper-right test on
the top test tier.