Netscout OneTouch AT 10G, Руководство пользователя

Страница: 44 / 248

OneTouch AT 10G
User Manual
42
You can exit the Setup Wizard at any time by selecting the EXIT
button .
To Start the Setup Wizard at a Later Time
You can run the Setup Wizard again, at any time, to create
additional Profiles.
1 Tap the TOOLS icon on the HOME screen.
2 Tap the Setup Wizard button.
The registration and cloud service setup sections of the wizard are
not included in
TOOLS

Setup Wizard because you only need to
complete them once.
Registering the OneTouch AT Analyzer
Upon first power-on, the Setup Wizard guides you through the
registration process.
Connect to the Management Port
To register directly from the analyzer, you must establish a wired
Ethernet connection to the analyzer’s management port. Connect
a cable from your network to the RJ-45 Ethernet connector at the
lower left side of the analyzer, next to the power connector.
After making the connection, tap the NEXT
button.
Handling connection problems
If you get an error message stating that the OneTouch Internet
connection was not established, follow these steps to
troubleshoot the problem.
Proxy Server
If a network connection was established at the management port
but the analyzer could not reach the OneTouch AT cloud site on
the Internet, the next screen displayed will give you the
opportunity to specify a proxy server.