NetModule NG800, Руководство пользователя

Страница: 91 / 223

NG800
User Manual for NRSW version 4.5.0.100
NAPT Inbound Rules
Inbound rules can be used to modify the target section of IP packets and, for instance, forward a
service or port to an internal host. By doing so, you can expose that service and make it available
from the Internet. You may also establish 1:1 NAT mapping for a single host using additional outbound
rules.
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
Firewall
Administration
Address / Port Groups
Filtering Rules
NAPT
Masquerading
Inbound Rules
Outbound Rules
NAPT Rules Inbound
This menu can be used to configure network address/port translation rules for inbound packets.
Description Source Target Redirect to
Apply
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.24.: Inbound NAPT
Please note that the specified rules are processed by order, that means, traversing the list from top to
bottom until a matching rule is found. If there is no matching rule found, the packet will pass as is.
Parameter Inbound NAPT Rules
Description A meaningful description of this rule
Map Context for this rule: Host, Network or Port-Range - see table below
Incoming interface The interface from which matching packets are received
Source The source address or network from which matching packets are re-
ceived
Target address The destination address of matching packets (optional)
Protocol The used protocol of matching packets
91