NETGEAR WNR834, Руководство по установке, Страница: 38 / 42

34 Default Configuration
Restoring the Default User Name and Password
You can restore the factory default configuration settings which resets the router’s User Name to
admin,
the Password to
password,
and the IP address to
192.168.1.1
. This procedure erases your
current configuration and restores the factory defaults.
To restore the factory default configuration settings:
1.
Use a sharp object like a pen or a paper clip to press and hold the default reset button, located
on the rear panel of the router, for about 20 seconds (see “Back Panel” on page 3 ).
2.
Release the reset button and wait for the router to reboot.
The factory default settings will be restored so that you can access the router from your web
browser using the factory defaults.
Firewall
Inbound (communications coming in from
the Internet) Disabled (bars all unsolicited requests except for
traffic on port 80, the http port)
Outbound (communications going out to
the Internet) Enabled (all)
Wireless
Wireless Communication Enabled
SSID Name NETGEAR
Security Disabled
Broadcast SSID Enabled
Transmission Speed Auto a
Country/Region United States (North America only; otherwise varies
by country and region)
RF Channel 6 until region selected
Operating Mode Up to 240 Mbps
Data Rate Best
Output Power Full
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network
conditions and environmental factors, including volume of network traffic, building materials and construction, and net-
work overhead lower actual data throughput rate.
Table 1. Home Router Default Configuration Settings (continued)
Feature Default Setting