If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight Cloud Portal or Insight app, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 26.
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > General.
The General page displays.
5. Select a Spanning Tree Protocol radio button:
•
Enable: STP is enabled.
•
Disable: STP is disabled. This is the default setting.
6. Click the Apply button.
Your settings are saved.
Enable or disable the network integrity check
function
The network integrity check function enables the access point to validate whether the
upstream link is active before the access point allows WiFi associations. Make sure that
the default gateway is configured correctly. By default, the network integrity check
function is disabled.
To enable or disable the network integrity check function:
1. Launch a web browser from a computer that is connected to the same network as
the access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window displays.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see What to do if you get a browser
security warning on page 44.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight Cloud Portal or Insight app, enter the
User Manual
143
Manage the Local Area Network
and IP Settings
Insight Managed WiFi 6E AXE7800 Tri-band Multi-Gig Access Point Model WAX630E
