Your settings are saved and the schedule becomes active. The WiFi signal is turned
off according to the schedule that you added.
Enable or disable MU-MIMO
Multiuser multiple input, multiple output (MU-MIMO) improves performance when
multiple MU-MIMO-capable WiFi clients transfer data at the same time. WiFi clients
must support MU-MIMO. This feature is enabled by default, but you can disable it.
Note: When MU-MIMO is enabled, Tx beamforming is automatically enabled and you
cannot disable it.
To enable or disable MU-MIMO:
1. Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 34.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Wireless Settings.
The Wireless Settings page displays.
5. Scroll down the bottom of the page.
6. Select or clear the Enable MU-MIMO check box.
Selecting this check box enables MU-MIMO. By default, MU-MIMO is enabled.
User Manual
133
Advanced WiFi and Radio
Features
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
