Installation Guide
Gigabit Ethernet Switch GS205/GS208
Estimated installation time: 5-10 minutes
Package Contents
This package includes:
•
Gigabit Ethernet Switch GS205/GS208
•
AC power adapter
•
Installation Guide (this document)
Prepare to Install the Switch
Place the switch on a flat horizontal surface such as a table,
desk, or shelf. You can use wall-mounting screws (not provided)
to hang the switch in an open space on a wall.
Make sure the selected location is:
•
Not in direct sunlight or near a heater or heating vent.
•
Not cluttered or crowded. There must be at least 2 inches
(5 cm) of air space on all sides of the switch.
•
Well ventilated (especially if it is in a closet).
You need a Category 3 (10 Mbps), Category 5 (100 Mbps), or
Category 5e (1000 Mbps) Ethernet cable with RJ-45 connectors
for each device you connect to the switch. Each Ethernet cable
must be less than 328 feet (100 meters).
Install the Switch and Connect Devices
1.
Place the switch on a flat surface or hook it onto the screws.
2.
For each device, insert one end of an Ethernet cable into a
port on the switch and the other end into the network port
on the device.
3.
Connect the power adapter cord into the back of the switch
and then plug the adapter into a power source (such as a
wall socket or power strip).
4.
Check the LEDs:
•
Verify that the Power LED is lit.
•
For each RJ-45 jack that is connected to a powered
device, check that the Link LED is lit and that it flashes
when activity occurs.
Note:
If any LED does not operate as indicated go to the
Troubleshooting section.
Power
GS208 8-Port
Gigabit switch
Modem
Firewall
Power
GS205_GS208_IG small.fm Page 1 Thursday, August 9, 2012 10:09 AM
