28
29
The tester contains five actions that are used to test the lamps
and toner of the
Measurement Unit
. It also contains a set of
fields that change when jump mat is connected or disconnect-
ed, when someone steps on the jump mat or when someone
enters or leaves the area covered by the photocells.
The
Test Tone
action tells the
Measurement Unit
to make a
one-second beep.
Left Light
and
Right Light
actions light the
specified lamp for a second. The
Panel Light On
action lights
the panel lights for one hour and the
Panel Light Off
action
turns off the lights.
When the jump mat is disconnected, the
Disconnected
field
is lit and when connected, the
Connected
field is lit. Note
that the
On Mat
/
Off Mat
fields are not lit when the mat gets
connected, since at that stage it is unknown whether there is
someone on the mat or not. Also note that the
On Mat
and
Off Mat
values are determined by pressure changes in the
mat, so if you change your center of gravity while standing on
the jump mat, the values may change even if you do not step
off the mat.
7.3 Regional settings
The
Regional Settings
view shown in Figure 47 is used to
change the measurement units. There are two possible length
units and two possible weight units. Changes to these settings
O
TH
ER F
U
N
C
TION
S OF P
O
WE
R
TI
M
ER SW
-3
0
0
7
Figure 46
Measurement Unit Tester
are saved into database and are loaded when the
Powertimer
SW-300
is started for the next time. Height and weight units
affect the subject’s height and weight settings and certain test
parameters.
The height and weight values are usually stored in millime-
ters and hectograms, so there might be minor rounding issues
when using inches and ounces as measurement units.
7.4 Database Manager
The
Database Manager
allows you to view how many entries
are in each of the
Powertimer SW-300
databases. It is meant
for maintenance purposes in case the databases are somehow
corrupted, for example if Palm is turned off while it is writing
to the databases. The message shown in Figure 48 is shown if
something is wrong with the databases.
The
Database Manager
shown in Figure 49 has two actions:
Check Databases
action is used to check the databases for
corrupt entries and to remove them. Database checking can
be a very time- consuming operation if the databases are
large. The
Clean Databases
action removes all entries from
the databases and resets the
Tests
and
Test Parameters
data-
bases to their default values.
Figure 47
Regional Settings
