NetComm InModem 56, Руководство пользователя

Страница: 8 / 28

7
YML545
C1
: Normal transmit carrier switching.
Result Codes :
OK n = 1
ERROR Otherwise
Dn Dial
This command instructs the modem to begin the dialing sequence. The dial string (n,
including modifiers and the telephone number) is entered after the ATD command. A dial
string can be up to 60 characters long. Any digit or symbol (
0
¾9, *, #, A, B, C, D) may be
dialed as touch-tone digits. Characters such as spaces, hyphens, and parentheses do not
coun
τ
¾they are ignored by the modem and may be included in the dial string to enhance
readability. The following may be used as dial string modifiers:
L Redials last number. Should be the first character following ATD, ignored
otherwise.
P Pulse dialing.
T
Touch-tone dialing (default).
,
Pause during dialing. Pause for time specified in Register S8 before processing the
next character in the dial string.
W
Wait for dial tone. Modem waits for a second dial tone before processing the dial
string.
V The modem switches to speakerphone mode and dials the number. An ATH
command may be used to disconnect the voice call.
@ Wait for quiet answer. Wait for five seconds of silence after dialing the number. If
silence is not detected, the modem sends a NO ANSWER result code back to the
user.
!
Hook flash. Causes the modem to go on-hook for 0.5 seconds and then return to
off-hook.
;
Return to command mode. Causes the modem to return to command mode after
dialing the number, without disconnecting the call.
^
Disable data calling tone transmission.
S=n Dial a telephone number previously stored using the &Zn=x command (see the
&Zn=x command for further information). The range of n is 0—3.
En Echo Command
This command controls whether or not the characters entered from your computer keyboard
are echoed back to your monitor while the modem is in command mode.
E0
: Disables echo to the compute r.
E1 : Enables echo to the computer (default).
Result Codes
:
OK n = 0, 1
ERROR Otherwise
Fn Online Data Character Echo Command
This command determines if the modem will echo data from the DTE. This modem does not
support the F0 version of the command. However, the modem will accept F1, which may be