NetComm Wireless NF15ACV, Руководство пользователя

Страница: 20 / 69

20
NetComm Wireless VDSL/ADSL Dual Band AC1200 WiFi Gigabit Modem Router with VoIP
www.netcommwireless.com
UM-00019 v1.0
Wireless
Wireless 2.4GHz/Wireless 5GHz
Basic Settings
The WLAN Basic Settings page for both the 2.4GHz and 5GHz wireless radios provide the most common settings that you might
need to configure in setting up your wireless network.
Refer to the table below for a description of each field.
FIELD DESCRIPTION
Disable Wireless LAN Interface Enable/disable the wireless LAN interface.
Band Select the desired band from the list. Using a combination of bands allows for compatibility with legacy devices.
Mode Configures the mode of the Wireless LAN interface.
Multiple AP
Enables multiple access points. When enabled, you can have up to four separate access points (networks). See
the Multiple Aps screenshot below.
SSID
Specifies the network name. Each Wireless LAN network uses a unique Network Name to identify the network.
This name is called the Service Set Identifier (SSID). When you set up your wireless adapter, you specify the SSID.
If you want to connect to an existing network, you must use the name for that network. If you are setting up your
own network you can make up your own name and use it on each computer. The name can be up to 32
characters long and contain letters and numbers.
Channel Width
Choose a channel width from the drop down list. Generally speaking, this should not be changed from the default
setting unless you are aware of the effect that the change will have.
Control Sideband
Select a control sideband. Generally speaking, this should not be changed from the default setting unless you are
aware of the effect that the change will have.
Channel Number
Select a channel number for the wireless network. When using multiple APs, ensure that you assign a different
channel number to each AP to avoid signal interference.
Radio Power (mW)
The maximum output power of the radio. Generally speaking, this should not be changed from the default setting
unless you are aware of the effect that the change will have.