NetApp StorageGRID Webscale SG6000 Series, Руководство пользователя

Страница: 86 / 174

5. For Original Port , enter the number of the port you want to remap.
6. For Mapped-To Port , enter the number of the port you want to use instead.
7. Click Add Rule .
The new port mapping is added to the table, and the remapping takes effect immediately.
8. To remove a port mapping, select the radio button for the rule you want to remove, and click Remove
Selected Rule .
Deploy appliance Storage Node
After installing and configuring the storage appliance, you can deploy it as a Storage
Node in a StorageGRID system. When you deploy an appliance as a Storage Node, you
use the StorageGRID Appliance Installer included on the appliance.
What you’ll need
• If you are cloning an appliance node, continue following the process in recovery and maintenance.
Recover and maintain
• The appliance has been installed in a rack or cabinet, connected to your networks, and powered on.
• Network links, IP addresses, and port remapping (if necessary) have been configured for the appliance
using the StorageGRID Appliance Installer.
• You know one of the IP addresses assigned to the appliance’s compute controller. You can use the IP
address for any attached StorageGRID network.
• The primary Admin Node for the StorageGRID system has been deployed.
• All Grid Network subnets listed on the IP Configuration page of the StorageGRID Appliance Installer have
been defined in the Grid Network Subnet List on the primary Admin Node.
• You have a service laptop with a supported web browser.
About this task
Each storage appliance functions as a single Storage Node. Any appliance can connect to the Grid Network,
the Admin Network, and the Client Network
84