NetApp StorageGRID Webscale SG6000 Series, Руководство пользователя

Страница: 47 / 174

2. After the controllers have booted up, confirm that each storage controller shows 99, which is the default ID
for an E-Series controller shelf.
Make sure this value is displayed on both storage controllers, as shown in this example E2800 controller.
3. If one or both controllers show other values, see Troubleshoot hardware installation (SG6000) and confirm
you completed the installation steps correctly. If you are unable to resolve the problem, contact technical
support.
Related information
E5700 and E2800 System Monitoring Guide
NetApp Support
Power on SG6000-CN controller and verify operation
Configure hardware (SG6000)
After applying power to the appliance, you must configure the network connections that
will be used by StorageGRID. You must configure SANtricity System Manager, which is
the software you will use to monitor the storage controllers and other hardware in the
controller shelf. You must also ensure that you can access the BMC interface for the
SG6000-CN controller.
Configure StorageGRID connections (SG6000)
Before you can deploy a StorageGRID appliance as a Storage Node in a StorageGRID
system, you must configure the connections between the appliance and the networks you
plan to use. You can configure networking by browsing to the StorageGRID Appliance
Installer, which is pre-installed on the SG6000-CN controller (the compute controller).
Access StorageGRID Appliance Installer
You must access the StorageGRID Appliance Installer to verify the installer version and
configure the connections between the appliance and the three StorageGRID networks:
the Grid Network, the Admin Network (optional), and the Client Network (optional).
What you’ll need
• You are using any management client that can connect to the StorageGRID Admin Network, or you have a
service laptop.
45