NetApp StorageGRID SG5600 Series, Руководство по установке и обслуживанию оборудования

Страница: 25 / 73

Task Description
Install drives If you have an SG5660, install 12 drives in each of the 5 drive
drawers.
You must install all 60 drives to ensure correct operation.
1. Put on the ESD wristband, and remove the drives from their
packaging.
2. Release the levers on the top drive drawer, and slide the
drawer out using the levers.
3. Raise the drive handle to vertical, and align the buttons on the
drive with the notches on the drawer.
4. Pressing gently on the top of the drive, rotate the drive handle
down until the drive snaps into place.
5. After installing the first 12 drives, slide the drawer back in by
pushing on the center and closing both levers gently.
6. Repeat these steps for the other four drawers.
Attach the front bezel
SG5612: Attach the left and right end caps to the front.
SG5660: Attach the bezel to the front.
Related information
E2700 Controller-Drive Tray and Related Drive Trays Installation Guide
E5600 Controller-Drive Tray and Related Drive Trays Installation Guide
Cabling the appliance
You must connect the two controllers to each other with SAS interconnect cables, connect the
management ports to the appropriate management network, and connect the 10 GbE ports on the
E5600SG controller to the Grid Network and optional Client Network for StorageGRID.
Before you begin
• You have Ethernet cables for connecting the management ports.
Installing the hardware | 25