NetApp AltaVault Cloud Integrated Storage Installation and Service Guide for Physical Appliances
71
Beta Draft
Hot-swapping controller power supplies
System maintenance
6.
Lower the cam handle to the fully open position, and then slide the power supply out of the chassis, as shown
below. Make sure that you support the power supply with your free hand.
7.
Identify power supply components as described in this table:
Installing power supplies on a controller
Before you begin, verify that the power supply you are installing is supported by your controller model.
To install a power supply
1.
Verify that the on/off switch on the power supply is in the OFF (O) position. If the power source has an on/off
switch, ensure that it is also set to the OFF (O) position.
2.
If
you
are not already grounded, properly
ground yourself
.
3.
With the cam handle in the open position, align the edges of the power supply with the opening in the system
chassis and gently push the power supply into the chassis until it is almost flush with the chassis, as shown below.
Component
Description
1
Power supply
2
Cam handle release latch
3
Power and fault LEDs
4
Cam handle
5
Power cord locking mechanism
Содержание AltaVault Cloud Integrated Storage 4.1
Страница 2: ......