34
NetApp AltaVault Cloud Integrated Storage Installation and Service Guide for Physical Appliances
Deploying AltaVault
Setting the Service Processor password
The system confirms your settings.
2.
To change an answer, enter the step number to return to. Otherwise press <enter> to save changes and exit. The
AltaVault appliance configuration wizard automatically saves your configuration settings. The CLI prompt
appears:
amnesiac>
If you chose to use DHCP, you can get the IP address of the appliance by running the following commands:
amnesiac> enable
amnesiac# configure terminal
amnesiac (config)# show interfaces primary
3.
To log out of the system, enter exit at each of the command-level prompts.
Setting the Service Processor password
The Service Processor (SP) is a subcomponent of the controller. There is no password on the Service Processor until
you set the password. The Service Processor password must be set separately from the AltaVault administrator
password.
To set the SP password
1.
Log in to the CLI using either the serial connection, or an SSH session using the configured primary management
interface set up using the CLI configuration wizard steps. For more information, see
appliance CLI configuration wizard” on page 33
2.
Enter configuration mode and set the Service Processor password in the controller using the following CLI
commands:
Step 3: Use DHCP on the
primary interface?
You are given the option to enable the DHCP to
automatically assign an IP address to the primary
interface for the AltaVault appliance.
For AltaVault virtual and physical appliances, DHCP is
not recommended. For AltaVault cloud-based virtual
appliances, DHCP is required.
Use DHCP? no
If no, continue with Step 4.
If yes, skip Steps 4 to 8.
Step 4: Primary IP address?
Enter the IP address for the AltaVault appliance.
Primary IP address? 10.10.10.6
Step 5: Netmask?
Enter the netmask address.
Netmask? 255.255.0.0
Step 6: Default gateway?
Enter the default gateway for the AltaVault appliance.
Default gateway? 10.0.0.1
Step 7: Primary DNS server?
Enter the primary DNS server IP address. You must
specify the primary DNS server for cloud provider name
resolution. If you do not specify a valid DNS server, the
system does not start.
Primary DNS server? 10.0.0.2
Step 8: Domain name?
Enter the domain name for the network where the
AltaVault appliance is to reside.
If you set a domain name, you can enter host names in the
system without the domain name.
Domain name? example.com
Wizard prompt
Description
Example
Содержание AltaVault Cloud Integrated Storage 4.1
Страница 2: ......
