Net2Edge LIB-306, Инструкция по установке

Страница: 6 / 25

Net2Edge LIB-306 Install Guide
Install Guide Rev. D www.net2edge.com Page 6 of 25
Features

Two/four 10/100/1000Mbps Base–T ports. Four/two 100/1000Mbps SFP ports. Any port can be
network (NNI) or client (UNI).

Two of the SFP ports support a proprietary 2.5Gbps mode.

TP ports support IEEE 802.3az Energy Efficient Ethernet for power saving.

Full bandwidth 1000Mbps switching, non blocking.

SNMP v1, v2c, and v3.

IPv6 and IPv4 support.

VLAN (802.1Q) Q-in-Q (C-Tag / S-Tag).

RMON and Syslog.

OAM Support: IEEE 802.3ah Link OAM, IEEE 802.1ag Service OAM, ITU-T Y.1731 Performance
Monitoring, and MEF E-LMI.

Loop Protection: ITU G.8032 and IEEE RSTP, MSTP.

G.8031 Linear Protection switching

IEEE 1588v2 PTP (Precision Time Protocol).

DC or AC power input (12VDC Barrel connector or 2-Pin, 21-60VDC Terminal block).

Jumbo Frame Support (10240 bytes maximum).

Wire speed loopbacks.

RFC 2544 Traffic Generation and Reports.

Last Gasp/Dying Gasp notification via SNMP trap. Monitor Rx and Tx Dying Gasp for each port.

SNMP traps configurable: System (Warm Start, Cold Start); Interface (Link Up. Link Down, LLDP);
AAA (Authentication Fail); Switch (STP, RMON).

Alarm inputs/outputs: RJ-45 connector with 2-IN and 2-OUT, 10-30VDC, 40mA maximum; optically
isolated from main board. Alarm indications via Syslog and SNMP.

E-LINE (EPL and EVPL) / E-LAN (EP-LAN and EVP-LAN) / E-ACCESS (ACCESS EPL and EVPL)
/ E-TREE (EP-TREE and EVP-TREE).

UNI or NNI configuration.

TOS (Type of Service) and Diffserv (Differentiated services).

QoS (802.1p Quality of Service): 8 queues; strict priority and DWRR, shaping, policing, P-bit and
DSCP.

Management via Industry standard CLI, Web, SSH/SSL & SNMP (v1, v2c, v3).

Port configuration, status, statistics, and monitoring.

RADIUS, and ACL.

Remote backup / restore configuration / firmware upgrades.

L2CP (Layer 2 Control Protocol).

LLDP (Link Layer Discovery Protocol).

Port Mirroring and Remote Mirroring.

Link Aggregation Control Protocol (LACP).

DDMI (Digital Diagnostics Monitoring Interface).

HQoS (Hierarchical Quality of Service) with Guaranteed Bandwidth Rate.

JSON (JavaScript Object Notation) RPC.

LLDP-MED per TIA-1057.

MEP BFDs (Bidirection Forwarding Detections).

MEP Route Trace.

MPLS-TP (Multiprotocol Label Switching).

PFC (802.1Qbb Priority Flow Control)

Traffic Test Loop (Y.1564, RFC2544, and TT-Loop functions).

UDLD (Uni Directional Link Detection) protocol support (RFC 5171).

Y.1564 Tests and Reports.