Nerival NEO-80, Руководство пользователя

Страница: 15 / 15

15
www.nerival.fi
Digital display code table
Fucntion code Function description
F1 Sensor signal active
F2 Opening door anti-collision signal active
F3 Closing door anti-collision signal active
F4 Access control signal active
F5 Interlock signal active
F6 Synchronization signal active
A1 Automatic mode
A2 Hold-open mode
A3 Sensor signal disabled
A4 Sensor and access control signals disabled
Error code Cause Solution
E0 System error Replace the controller
E1 The motor is not connected Check motor connection
E2 Motor line failure Check motor connection, replace the motor
E3 No motor coil detected Check motor connection
E4 12VDC abnormal voltage Check the electric lock, 12V voltage port
E5 Encoder direction is wrong Check setting no. 27
E6 Voltage is too high Check voltage
E7 Voltage is too low Check voltage
E8 No door was detected Check the attachment of the pull and push arm
E9 The door does not close
Check the door, remove obstacles in front of the
door