Nerf C17DR00G0, Руководство пользователя и инструкции по установке, Страница: 10 / 44

en
Basic operation
10
▶
Never empty the evaporator dish immediately after
switching off the appliance.
▶
Allow the appliance to cool down before cleaning.
When you open the appliance door, hot water may flow
out of the appliance.
▶
When opening the door, do not stand too close to
the appliance.
▶
Open the appliance door carefully.
▶
Keep children away from the appliance.
▶
If the evaporator dish overflows, do not pour more
water into the water tank.
ATTENTION!
Using unsuitable liquids may damage the appliance.
▶
Do not use distilled water, highly chlorinated tap wa-
ter (>40 mg/l) or other liquids.
▶
Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
Requirement:
The water hardness range is set cor-
rectly.
→
Page 8
1.
Open the appliance door.
2.
Remove the water tank from the tank recess.
3.
Fill the water tank with cold water up to the
max
mark.
4. Close the tank lid.
5.
Slot the full water tank back into the water tank re-
cess.
6.
Check that the front end of the water tank is flush
with the opening of the water tank recess.
7.
Close the appliance door.
7.5 Refilling the water tank
If the water tank runs dry during operation, steaming
will be paused.
1. Open the appliance door carefully.
2.
Remove the water tank from the tank recess.
3. Fill the water tank with water.
4.
Slot the full water tank back into the water tank re-
cess.
5.
Close the appliance door.
6. Press to resume operation.
7.6 Setting the heating function and
temperature
When you switch on your appliance, the display will
suggest a heating function and temperature. If you wish
to use the suggested setting, you can start the appli-
ance immediately by pressing . If you wish to use a
different setting, you will need to change the values.
Requirement:
The water tank contains sufficient water.
1.
Press to switch the appliance on.
a
The heating functions will then be displayed.
2.
Use the or button to select the required heating
function.
3.
Use the button to navigate to the next row.
4.
Use the or button to select the required temperat-
ure.
5.
Press ⁠.
a
The appliance will now start.