WorldPhone Liberator – Chapter 4. Data Service
4.3
Starting from PC
Starting from PC
Procedure
1
Turn on the WorldPhone Liberator,
2
Open the terminal emulator on the PC, and connect. Key in the
start prompt
at+wneradte
.
at+wneradte
Terminal MMI started in mode: MMI (multilingual)
CTRL-f to switch font
CTRL-x to return to AT command mode.
Press space to continue
Note!
When using the
terminal emulator,
the data/printer port
(DTE) is
busy and is not
capable of receiving
a data call.
The user is prompted for the 4-8 digit Personal Identification Number
each time the WorldPhone is switched on:
3
a
Enter the SIM PIN code, and press
ç
:
3
b
If no SIM card is inserted, the "Phone PIN" will be prompted for.
4
During the satellite search, beep tones will be heard in the handset
slow intermittent tones when
searching for
any
satellite
.
rapid intermittent tones when
searching for a
specific satellite
(faster when searching for a single
satellite).
5
When receiving a satellite signal, a short tone will sound. If it is an
Inmarsat satellite, a continuous tone will sound with varying frequency
(provided the
Tone
is ON, see next page)
.
When closing in on a satellite, the tone should increase in frequency.
WorldPhone Liberator
>SIM PIN:
_
Press “Help” for an introduction
470 SIM <Del Ok
Ctrl + T for Help <+U> <+I>
<+O> <+P>