41
Nera F77
Continuing the Saturn tradition
Slide
nut A and gasket B
onto cable.
Prepare cable according to diagram.
Caution:
Do not damage braid.
Push braid back and widen it slightly, but do not comb it
out. Cut off dielectric 1.7 mm perpendicular to cable axis.
Taper braid towards center conductor.
Position braid
clamp C
so that its shoulder fits against
cable sheath.
Fold back braid over
clamp C
and trim overlapping braid.
Slide
clamp D
underneath the braid.
Check dimension of 0.8mm.
Heat inner
contact E
using a soldering iron (approx. 40
W) and flow small amount of tin into bore. Push cable
inner conductor into bore, immediately remove soldering
iron to prevent melting of the dielectric.
Push prepared cable into
connector body F
and tighten
nut A
.
Do not rotate cable in connector body.
A B C
D
E
F
C
D E
F
A
B
A
B
A
B
C
A
B
A
Mounting connector type 11N-50-3-54 (for cable RG223/U)
Tools and materials
required:
•
Stanley blade
•
Scissors
•
Solder Sn/Pb 60/40
activated rosin flux
•
Spanner
7 mm (74 Z-0-0-38)
8 mm (74 Z-0-0-16)
13 mm (74 Z-0-0-37)
0
10
20
30
40
50
mm
scale
