Neptune 13458-000, Руководство по установке и обслуживанию

Страница: 108 / 150

The digital meter operates from -30°C to +85°C. The values
displayed are calibrated electronically in production and are
accurate to within a few percent.
l
If the Battery Sense is not connected, the voltage
displayed is in error by the voltage drops in the battery
wires.
l
If the battery is located more than 5 meters from the
controller, the Battery Sense connection is recommended.
Manual Disconnect
The ProStar PS-15M and PS-30M controllers have a push button
next to the digital display which can disconnect the load or both
load and solar. A second push of the button returns the controller
to normal operation.
l
LOAD OFF - A brief push of the button (less than two
seconds) disconnects the load. The solar remains on and
charging.
l
LOAD and SOLAR OFF - If the button is held for two
seconds, the solar is disconnected.
When the button is pushed, the red LED inside the cap lights up.
In addition, the load or both load and solar displays
OFF
in the
digital meter to indicate the disconnected state.
Display Disconnects and Protections
The following protection functions and disconnect conditions are
displayed in the digital meter when they occur.
l
Lud
- Low voltage disconnect (load only)
l
Hud - High voltage disconnect (both solar and load)
l
Hot - High temperature disconnect (both solar and load)
l
OCP - Overcurrent and short circuit protection (load, solar,
overcurrent)
l
0.0 - Short circuit protection (solar only)
90 R900 Gateway Installation and Maintenance Guide
Appendix A Solar Power Information