PCIe-PoE354at/PCIe-PoE352at User’s Manual
Copyright © 2015 Neousys Technology Inc. All Right Reserved.
Page 9 of 31
Chapter 3 Getting Start
3.1
Configure Board ID of PCIe-PoE354at/352at
PCIe-PoE354at/352at offers the feature of per-port power on/off control. You can manually
cut off or resume the power delivered to connected PoE+ PD device using Neousys’
provided API. This feature enables the capability of failure recovery in the field as you have
the way to rest each PD device. To support per-port on/off control for multiple cards,
PCIe-PoE354at/352at incorporates a DIP switch to configure user-defined board ID. The
board ID can be used as a parameter in API to specify the PCIe-PoE354at/352at card.
The DIP switch is located on the upper-left corner of PCB. P1 ~ P3 of DIP switch are used
to specify the board ID. You can configure the board ID by set the position of P1 ~ P3
according to the following table.
Board ID
DIP Switch Position (P1 ~ P3)
0
1
