Neopost MaxiMailer HD, Руководство оператора

Страница: 37 / 69

37 MaxiMailer HD Operator Manual
5.9.8
setting the
miscellaneous
options
Ensure that the Miscellaneous tab in the configuration screen is
selected. This section allows you to select the required station for data
logging (where used), and also for the address carrying document.
note: This screen will only be available to personnel with
supervisor access.
setting the
datalog unit
If you are using datalogs, set the unit you wish to use to record the log
from by pressing ‘Logging from’. By default, this will be the prime unit.
See page 42 for further details of datalogs.
address
Carrier
This allows you to select the unit that carries the address document
(this will normally be the DTI). note: this can also be selected from
‘Feed options for feed unit’ (see page 32). Whichever is set the later
takes precedence.
Confirm
Calibration
Select ‘No’ if you wish the machine to continue running after a
calibration cycle is performed (by default, machine will stop and await
confirmation of envelope contents).
MPPC
settings
Available only if an MPPC unit is fitted. For ‘Control Mode’, select
between Inserter, franker or Off (for 140 series, Inserter will
normally be selected). ‘Trigger Delay’ allows a small pause between
detecting the edge of the envelope and reading the label in the window.
This allows some adjustment of reading of the label position. Units are
in milliseconds.
After making any changes, click the
save button at the bottom of the
screen, and then the exit button to return to the list box.