Neomatica ADM35, Руководство по эксплуатации

Страница: 8 / 22

Neomatica LLC, Bluetooth sensor ADM35, ADM35H, version 1.1 dd 02.07.2021
8
operation. The signal strength from -85 dBm up to 90 dBm is considered as sufficient for operation,
but problems may occur at a slight deterioration of conditions.
4.1.3 Setting
The sensor is supplied with optimal factory settings. If the factory settings are suitable for
the task, no sensor configuration is required. You can immediately connect the sensor to the
tracker.
By default, the data transfer period is set to 15 seconds and all sensors are active, except
for the Hall sensor. If you need to use a Hall sensor, you should enable the corresponding option.
Recording to the archive is disabled by default, to use this function, you should enable the
corresponding option and configure the frequency of recording to the archive.
The readings of all active sensors are recorded in the archive.
Main sensor parameters available for configuration:
•
Mode of data transfer
This parameter determines the technology via which the data will be transmitted. Bluetooth
Long Range technology allows increasing the distance from the sensor to the receiving device and
to increase the reliability. The receiving device should support data receipt via such technology.
BLE technology allows transferring data over shorter distances. Such a technology is
supported by most devices. Mode BLE is given by default.
•
Data tranmission period
This parameter determines transmission frequency of the data via the Bluetooth LE radio
channel, as well as the frequency of measurements. The measurement is performed by all active
detectors before sending the readings. In the intervals between the measurement and sending
readings, the sensor is in a sleep mode.
Increase of the transmission period extends the battery life, but reduces the frequency of
readings update, and also increases the time switch to the setting mode. By reducing this
parameter you decrease the battery life. The recommended value is 15 seconds.
•
Hall sensor
Activation / deactivation of the Hall sensor
It is recommended to activate this sensor only when it is necessary to use it, because its
activation leads to an increase in energy consumption. When the Hall sensor is activated, an
extraordinary exit from the sleep state and sending readings may happen.