13
General / Trigger
Your Device has the ability to send a request over IP to another Device. This request can then be used to
trigger an Action on the remote Device. Depending on your other Device, you could for instance switch on a
Power Outlet, close or open a Relay or send an SNMP Trap, an email or a Syslog message.
Trigger Server enabled
Check this box if you want to enable the Trigger function.
The Trigger function must be activated on both the emitter device (your Device) and the target
Device.
Trigger Port
Port number used by the Trigger function, default is 52389.
The Trigger function must be activated on both the emitter device (your Device) and the target Device
and both must use the same Port number.
LOGOUT
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES
Click "Apply Changes" at the bottom of the page to save changes.
