NeoDen NeoDen10, Руководство пользователя

Страница: 23 / 64

23
（
1
）
Panelized mark point
It is mainly used for multiple identical PCB boards consistent of the whole board, when place every panel board, the
machine will rescan small panel board’s mark point.
（
2
）
Single mark point
It is mainly used for a single PCB board and multiple identical PCB boards consistent of the whole board (Notice:
coordinate programming is done as a single board)
Generally, need to select 2 or 3 mark points.
(3)Manual alignment:
If the fiducial point quality is poor and the recognition is not accurate, the reference position can be determined manually. If
there is no fiducial point on the PCB, which can through some location holes and set up some special reference point
manually to replace and confirm reference position. Note: Generally use SMD1 coordinate in chip list and the one that is
relatively easy to find far away from SMD1 as fiducial points .In this way, the relative placement effect will be better during
placement, the reference point is determined manually.
(4) Auto alignment
The machine will scan and align fiducial points automatically.
6.2 Mark Point information
Mark point Coordinate: Import the coordinate automatically status: the data collection of mark point, which through PCB
circuit board to find mark point coordinate information directly, and input directly. Manual programming status:Select mark
point on the list and click “align”,enter the image capture page,and then find the center of the mark point via movement,
click "Mark align" see below figure, and then click "Save and Back" to go back to main page.