13
After setup, click “create panelized list”, the data will be generated accordingly in the blank.
(3)PCB angle correction: angle deviation of PCB board compare to rails
(4)Bad board detection
：
used for find the bad PCB board and skip
4.1.3.PCB mark point setting
Function: After completing setup of the mark points, with which the machine can locate the
position of PCB and identify the set up mark points, so that the next step can be followed
Operation method:
(1) Mark point on single PCB: this mainly applies on single PCB or a whole board that consists of
a few boards (take them as a single board ).General we need to set 2-3 mark points.
(2) Panelized PCB: this mainly applies on multiple PCB(we need to set mark points on each
PCB )
(3) Manual alignment
If there is no mark point on PCB, you can use some positioning holes or some other
referential points as subsidies to locate the PCB.
Fig.3-1
