Page
20
of
76
4 Software
4.1 Start Measurement Software
After turning on the instrument, the NEO Software will automatically be started. If not, the
software can b
e started by the shortcut “ENA Measurement Software”
The number of systems can be configured at: „Setup“ – „Misc.“ – „Multisystem“.
If one system is selected, then automatically the 4U4I configuration will be active.
If two systems are selected then depending on the instrument version the 3U3I+1U1I config
(PQA8000) or the 3U3I+3U3I config (PQA8000M, PQA8000P) will be applied..
In the software you can switch between the systems with this button:
The button is either located on the bottom of the screen (Measurement mode) or on the left
side (Configuration).
The measurement software is included with the device, while additional report
and management software can be installed as it may be necessary. For further
information, we would like to refer to the software manual.
Note: The instrument always starts-up in the last used configuration (Sampling Rate, connection,
range, language etc.)
Содержание PQA8000
Страница 32: ...Page 32 of 76...